Plug the non-clogged side with a heavy stopper or a wet rag.

Pull the plunger up sharply on the final stroke to create a vacuum suction that helps break up the debris. Repeat this process three times if the water does not immediately recede. 3. Clear the Garbage Disposal Unit

If the clog resides specifically on the side of your garbage disposal, the internal impellers may be jammed by food debris, causing water to pool.

– Place plunger over the open drain. Make sure it’s fully covered with water. Plunge vigorously up and down 15–20 times, then remove rag and check if water drains.

Locate the hexagonal socket centered on the absolute bottom exterior of the disposal motor housing. Insert a 1/4-inch Allen wrench (hex key) directly into this socket. Turn the wrench back and forth clockwise and counterclockwise. This manually rotates the internal flywheel to break loose jammed debris.

For stubborn clogs that resist chemical reactions, mechanical force is required, specifically through the use of a cup plunger. Unclogging a double sink requires a specific plunging technique that differs from a single basin. Because the two drains are connected, plunging one side may simply force air and water up into the other basin rather than pushing the clog down. Therefore, one must first plug the unaffected drain opening with a wet rag or a drain plug to create a vacuum seal. Once the second drain is sealed, place the plunger over the clogged drain, ensuring there is enough water in the basin to cover the cup, and plunge vigorously for several minutes. This creates the necessary pressure to dislodge the physical blockage.

Remove the trap and clear out any debris (usually hair, food scraps, or small objects). Reassemble and test the flow. 5. Use a Sink Auger (Snake)

– Remove standing water if possible. If water is high, bail it into a bucket.

Pour enough water into the clogged side to submerge the rubber cup of your plunger completely. Water transmits force far more efficiently than air.