The bad block threshold was exceeded. Modify the [Format] section in your MP.ini file to allocate a higher percentage of reserve sectors.
Launch the diagnostic software and locate the following parameters: Must read PS2251-XX .
Before deploying MPALL v5.03.0A-DL07, you must verify your USB controller generation. This specific version provides stable compatibility with the following integrated circuits (ICs): Widely used in USB 3.0 drives. PS2251-67: Common in budget-oriented USB 3.0 devices. PS2251-03: Legacy high-speed USB 3.0 controllers. PS2251-68: Modern entry-level controller variations. 📋 Step-by-Step Diagnostics Procedure phison mpall v5.03.0a-dl07
enter a value in the "Target Capacity" box unless you are trying to create a fixed-size partition.
Under the [PenDriveID] section, input the Vendor ID (VID) and Product ID (PID) found during diagnostics. The bad block threshold was exceeded
Scans, identifies, and maps out dead NAND sectors. 🔍 Supported Controllers and Compatibility
Under [Firmware] , point the directory path directly to your downloaded burner file and firmware file: Before deploying MPALL v5
Set to 2.0 (even if using a 3.0 port), as recommended in technical forums like NI Community .
Plug your Phison-based USB drive into a USB 2.0 port if possible (more stable for flashing).
Identify your controller (e.g., PS2251-07) and Flash ID using tools like ChipGenius or Flash Drive Information Extractor before starting. Step-by-Step Guide 1. Initial Setup